Honeywell Xenon XP 195 Series User Manual page 311

Replace an Interface Cable
1. Turn off the power to the host system.
2. Disconnect the scanner's cable from the
3. Locate the small hole on the back of the
4. Straighten one end of a paper clip.
5. Insert the end of the paper clip into the small
6. Replace with the new cable.
Replace Cables and Batteries in Cordless Systems
Replace an Interface Cable in a Base
1. Turn the power to the host system OFF.
2. Disconnect the base's cable from the terminal or computer.
3. Turn the base upside down.
4. Pull the connector out while maintaining pressure on the connector release
Xenon XP User Guide
terminal or computer.
scanner's handle. This is the cable release.
hole and press in. This depresses the retention
tab, releasing the connector. Pull the connector
out while maintaining pressure on the paper
clip, then remove the paper clip.
Insert the connector into the opening and press firmly. The connector is keyed
to go in only one way, and will click into place.
clip.
CCB01-010BT
Base:
Cable
Release
CCB-H-010BT Base:
293