Table of Contents
Advertisement
If you have changed data format settings, and wish to clear all formats and return
to the factory defaults, scan the Default Data Format code below.
Show Data Format
Scan the barcode below to show current data format settings.
Add a Data Format
Step 1.
Step 2.
Step 3.
Note: 099 indicates all terminal types.
Step 4.
Note: 99 indicates all symbologies.
Step 5.
132
Scan the Enter Data Format symbol
Select Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate
formats. This allows you to save a total of 4 different data formats. To
program your primary format, scan 0 from the
beginning on page 311. If you are programming an alternate format,
scan 1, 2, or 3, depending on which alternate format you are
programming. (See
further information.)
Terminal Type
Refer to
Terminal ID Table
for your PC. Scan three numeric barcodes from the
beginning on page 311, to program the scanner for your terminal ID (you
must enter 3 digits). For example, scan 0 0 3 for an AT wedge.
Code I.D.
In the
Symbology Charts,
which you want to apply the data format. Locate the Hex value for that
symbology and scan the 2 digit hex value from the
beginning on page 311.
If you wish to create a data format for all symbologies, with the exception
of some specific symbologies, refer to B8
If you are creating a data format for Batch Mode Quantity, use 35 for the
Code I.D.
Length
Specify what length (up to 9999 characters) of data will be acceptable for
this symbology. Scan the four digit data length from the
* Default Data Format
Data Format Settings
(page
Primary/Alternate Data Formats
(page 134) and locate the Terminal ID number
beginning on page 297, find the symbology to
133).
Programming Chart,
on page 149 for
Programming Chart,
Programming Chart,
(page
147).
Programming
Xenon XP User Guide
Advertisement
Table of Contents
