Husqvarna P 524X Operator's Manual page 50

Problem
The transmission does not have suffi-
cient power
The battery does not charge
There is vibration in the product
The cutting result is unsatisfactory
Display - Troubleshooting
Symbol
50
Cause
The bypass valves are not fully closed.
There is no oil in the transmission or the oil level is too low. Refer to
check of the transmission oil level on page 42 .
The transmission oil is overheated.
The battery is defective. Speak to your Husqvarna servicing dealer.
The connection at the cable connectors on the battery terminals is bad.
The blades are loose. Refer to
One or more of the blades are not balanced. Refer to
on page 40 .
The engine is loose.
The bevel gear is loose.
The hydraulic pump is loose.
The engine is defective.
The drive shaft is defective.
There is an object in the PTO belt pulleys.
Rubber elements are hard or damaged.
The blades are blunt. Refer to
The grass is long or wet. Refer to
The cutting deck is skew.
There is grass blockage in the cutting deck. Refer to
page 26 .
The tire pressure is different on the right and left sides. Refer to
sure on page 32 .
The product is operated at a too high speed. Refer to
result on page 23 .
The engine speed is too low. Refer to
The drive belt slips.
Name
Indicator of hydraulic oil
temperature
To examine the blades on page 40 .
To examine the blades on page 40 .
To get a good cutting result on page 23 .
Shows on the display
The symbol shows.
The symbol flashes
quickly.
To examine the blades
To clean the product on
To get a good cutting
Technical data on page 54 .
Cause
The engine temperature is too high.
Speak to your Husqvarna servicing
dealer.
1902 - 003 - 09.02.2023
To do a
Tire pres-