Husqvarna P 524X Operator's Manual page 17

To remove the cutting deck
1. Push the switch for the electric lift to lower the
cutting deck. Lower the cutting deck fully until you
hear a pattering sound.
CAUTION:
minimum of 2 seconds after the cutting
deck touches the ground. This is to
make sure that the cutting deck is in float
position.
Note:
The pattering sound from the frame tunnel
does not mean that the product is defective.
2. Park the product on level ground.
3. Apply the parking brake.
4. Stop the engine.
5. Put the ignition key to neutral position.
6. Release the clip on the front cover with the tool
attached to the ignition key, and remove the cover.
7. Set the cutting height lever in position 1 (S)
(servicing position). Refer to
height on page 22 .
1902 - 003 - 09.02.2023
Hold the switch a
To adjust the cutting
8. Pull the spring handle out from the spring holder to
loosen the drive belt tension.
9. Remove the drive belt and put it in the belt holder.
10. Hold the front edge of the cutting deck with 2 hands
and pull it out.
11. Lower the cutting deck fully.
12. Open the equipment frame lock.
17