Husqvarna P 524X Operator's Manual page 20

2. Push in the PTO button to disengage the drive on
the cutting deck.
3. Move the throttle control to the middle position.
4. If the engine is cold, move the choke control fully
rearward.
5. Turn the ignition key to the start position.
6. When the engine starts, immediately release the
ignition key to neutral position.
CAUTION:
more than 5 seconds at a time. If the
engine does not start, wait 15 seconds
before you try again.
20
Do not run the starter for
7. Push the choke control gradually forward to the end
position.
8. Let the engine run at half throttle for 3-5 minutes
before you apply a heavy load.
9. Push the throttle control to full throttle position.
CAUTION:
the engine is at full speed causes strain
on the drive belts. Do not apply full throttle
until the cutting deck is lowered to the mow
position.
To start the engine (P 524X EFI)
1. Apply the parking brake.
2. Push in the PTO button to disengage the drive on
the cutting deck.
3. Move the throttle control to the middle position.
To engage the blades when
1902 - 003 - 09.02.2023