Husqvarna P 524X Operator's Manual page 5

The last digit of the hour meter for the operation period,
shows tenth of an hour (6 minutes).
The time with ignition on but engine off, is not registered.
Note:
The total hour meter (A) only shows full hours.
Note:
A operation period is the time the engine been
turned on during 1 day. A new operation period starts if
the engine is turned off for a minimum of 6 h.
A
Mower control module
The product has a mower control module that gives the
operator information about the product. The information
shows on the display on the instrument panel. Refer to
Display on page 6 .
The mower control module enables the servicing dealer
to connect to the product when they do servicing.
Husqvarna Connect
The product has wireless technology and can connect
to mobile devices that have the Husqvarna Connect app
installed. The Husqvarna Connect app is a free app for
your mobile device. The Husqvarna Connect app gives
extended functions for your Husqvarna product:
• Lock and unlock function to prevent not approved
operation of the product.
• Extended product information.
• Information about, and help with, product parts and
servicing.
Husqvarna Fleet Services
Husqvarna Fleet Services
gives the commercial fleet manager an overview of all
products. For more information about Husqvarna Fleet
™
Services , refer to www.husqvarna.com.
To connect to the product with Husqvarna
™
Fleet Services
1. Download the Husqvarna Fleet Services
your mobile device.
2. Log on to the Husqvarna Fleet Services
3. Follow the instructions about how to pair the product
with Husqvarna Fleet Services
PTO (Power Take-Off) button
The PTO button engages and disengages the PTO
clutch and the cutting deck or other equipment
connected to it. The correct start conditions must be
1902 - 003 - 09.02.2023
™
™
is a cloud solution that
™
app to
™
app.
™
.
obeyed to engage the drive of the blades. Refer to
a check of the operation conditions on page 13 for the
correct start conditions.
• Pull the PTO button out to engage the drive to the
blades or other equipment.
B
• Push the PTO button in to disengage the drive to the
blades or other equipment.
Headlights
The headlight has work light and high beam light.
• Push the power switch to position (A) to make the
lights go off.
• Push the power switch to position (B) to make the
work light come on.
• Push the power switch to position (C) to make the
high beam light and the work light come on.
The work light stays on for 3 minutes after the ignition
key is set to STOP. When the headlights are on, the
display shows the headlight symbol. Refer to
page 6 .
Forward and rearward pedals
The speed is gradually adjusted with 2 pedals. The left
pedal (A) is used to move forward, and the right pedal
To do
B
A
C
Display on
5