Husqvarna P 524X Operator's Manual page 41

7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil slowly through the hole for the dipstick.
Use an oil with viscosity that agrees with the
temperature ranges in the figure.
-20°C -10°C 0°C
SAE5W-20
-4°F -14°F 32°F
CAUTION:
types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
To replace the engine oil and the oil
filter
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING:
for more than 1–2 minutes before you drain
the engine oil. The engine oil becomes very
hot and can cause burn injuries. Let the
engine become cool before you drain the
engine oil.
WARNING:
your body, clean with soap and water.
1. Remove the engine cover.
1902 - 003 - 09.02.2023
10°C 20°C 30°C 40°C
SAE40
SAE30
SAE20W-50
SAE10W-40
SAE10W-30
50°F 68°F 86°F 104°F
Do not mix different
Do not operate the engine
If you spill engine oil on
2. Put a container below the oil drain plug.
3. Remove the dipstick.
4. Remove the oil drain plug from the engine.
5. Let the oil run out into the container.
6. Attach the oil drain plug and tighten it fully.
7. Turn the oil filter counterclockwise to remove it.
8. Lightly lubricate the rubber seal on the new oil filter
with new oil.
9. To attach the oil filter, turn it clockwise by hand until
the rubber seal is in position, then tighten a half turn
more.
10. Fill with new oil as given in
54 .
11. Start the engine and let it idle for 3 minutes.
12. Stop the engine and make sure that the oil filter does
not leak.
13. Fill with oil to compensate for the oil held in the new
oil filter.
Note:
For safe disposal of used engine oil, see
Disposal on page 53 .
Technical data on page
41