Husqvarna P 524X Operator's Manual page 21

4. Turn the ignition key to the start position.
5. When the engine starts, immediately release the
ignition key to neutral position.
CAUTION:
more than 5 seconds at a time. If the
engine does not start, wait 15 seconds
before you try again.
6. Let the engine run at half throttle for 3-5 minutes
before you apply a heavy load.
7. Push the throttle control to full throttle position.
CAUTION:
the engine is at full speed causes strain
on the drive belts. Do not apply full throttle
until the cutting deck is lowered to the mow
position.
To operate the product
1. Make sure that the bypass valves are closed. Refer
To disengage the hydrostatic transmission on
to
page 23 .
2. Start the engine.
1902 - 003 - 09.02.2023
Do not run the starter for
To engage the blades when
3. Press the parking brake pedal down and then
release it to disengage the parking brake.
4. Carefully press down one of the speed pedals. The
speed increases the more the pedal is pressed
down. Use pedal (A) to move forward, and pedal (B)
to reverse.
5. Release the pedal to brake. To brake harder, press
down the other speed pedal.
6. Select the cutting height. Refer to
cutting height on page 22 .
7. Push the switch for the electric lift to lower the
cutting deck. Lower the cutting deck fully until you
hear a pattering sound.
CAUTION:
minimum of 2 seconds after the cutting
deck touches the ground. This is to
A
B
To adjust the
Hold the switch a
21