Husqvarna P 524X Operator's Manual page 42

To do a check of the transmission oil
level
1. Use the oil dipstick to read the oil level in the
transmission.
2. The oil level must be between the marks on the
dipstick.
3. If the oil level is too low, fill with the type of oil given
Technical data on page 54 .
in
To do a check of the oil level in the
hydraulic system
1. Tilt the seat forward.
2. Clean the area around the oil cap with a dry cloth.
3. Remove the oil cap and examine the hydraulic oil
level. Correct level is 40–60 mm from the top of the
strainer.
4. If the oil level is too low, fill with the type of oil given
Technical data on page 54 .
in
To adjust the hydraulic pump belt
1. Fold the operator seat forward.
42
2. Remove the protection plate below the seat.
3. Remove the 2 belt protection covers.
4. Loosen the 3 screws (A) on the pump belt slide.
A
B
C
5. Loosen the locknut (B) on the adjustment screw.
6. Turn the adjustment screw (C) for the pump belt until
the belt has the correct tension.
7. Assemble in opposite sequence.
1902 - 003 - 09.02.2023