Stiga T 92 Series Operator's Manual page 270

the choke position in the carburettor
during engine ignition and heating.
5.7 PARKING BRAKE LEVER
This lever stops the machine from
moving when it has been parked.
This lever has two positions (fig.
15.D), corresponding to:
1. Brake not engaged. To release
the parking brake, press the pedal
(fig. 13.A, 14.A). The lever returns
to the brake disengaged position.
2. Brake engaged. To engage the
parking brake, press the pedal
down as far as it will go (fig. 13.A,
14.A) and move the lever to the
brake engaged position. When you
take your foot off the pedal it will be
blocked in the lowered position.
5.8 HEADLIGHTS SWITCH
This button (fig. 15.E) is used to
control the headlights when the key
(fig. 15.A) is in the «ON» position.
5.9 CUTTING DEVICE ENGAGE AND
DISENGAGE FUNCTIONS
This control is used to engage and
disengage the cutting device by using
of an electro-magnetic clutch:
1. Cutting device engaged.
2. Cutting device disengaged.
When the cutting device are
disengaged, a brake is applied
simultaneously in order to stop them
rotating within a few seconds.
NOTE The "Cutting device disengaged"
condition is indicated by the lamp (fig. 16.A).
NOTE If you engage the cutting device
without taking the necessary safety
precautions, the engine shuts down and
cannot be restarted (see par. 6.2.2)
EN - 11
Mushroom type button pulled
out (fig. 15.F.1) or button
pressed (fig. 15.F.2) .
Mushroom type button
pressed (fig. 15.F.1) or button
released (fig. 15.F.2) .