Electrical Connections - Empire Comfort Systems DVLXG75BP90N-1 Installer's Manual

Direct vent zero clearance gas fireplace heater

Hide thumbs

Table Of Contents

Table of Contents

All wiring should be done by a qualified electrician and shall be

in compliance with all local, city and state building codes. Before

making the electrical connection, make sure that the main

power supply is disconnected. The fireplace, when installed,

must be electrically grounded in accordance with local codes, or

in the absence of local codes, with the National Electrical Code

ANSI/NFPA 70 (Latest Edition).

When creating the cavity for the fireplace, consideration must be

given to the location of an appropriate power supply. A grounded

110/120 volt mains power connection must be available within 2.5

feet (1 meter) of the bottom right of the fireplace.

120VAC

MAINS

SUPPLY

(IN)

A mains isolation switch which is accessible from outside the

cavity can also be used to disconnect the power.

Regardless of the method used, it MUST ALWAYS be possible

to safely isolate the electrical supply to the appliance after it has

been fully installed.

This appliance must not be located immediately below a socket

outlet. No additional power supply is required for the power flue.