Electrical Connections - Empire Comfort Systems DVL36BP30 Series Installation Instructions Manual

All wiring should be done by a qualified electrician and
shall be in compliance with all local, city and state building
codes. Before making the electrical connection, make sure
that the main power supply is disconnected. The fireplace,
when installed, must be electrically grounded in accordance
with local codes, or in the absence of local codes, with the
National Electrical Code ANSI/NFPA 70 (Latest Edition).
The junction box is installed on the right side of the fireplace.
Wiring must be fed to the junction box and attached to the
receptacle that is provided. Leave approximately 6 inches of wire
in the junction box for connection.
Attach black wire to one side of the receptacle and white wire to
opposite side of receptacle. The ground wire should be attached
to the green (ground) screw. See Figure 19.
120 VOLT POWER SUPPLY
WHITE
(NEUTRAL)
41978-1-1220

ELECTRICAL CONNECTIONS

CAUTION
JUNCTION BOX
BLACK (HOT)
BRASS SCREWS
GREEN SCREW
SILVER SCREWS
GROUND
Figure 19
Figure 20
If a remote receiver or wall switch is being used, feed wiring
through the bushing (included in hardware pack) and snap into
hole between junction box opening and gas-line opening. See
Figure 21.
Install the receptacle into the junction box. Attach cover plate
and bracket. After the wiring is completed to the junction box and
receptacle, install the junction box to the lower right side of the
fireplace as shown in Figure 21.
REMOTE RECEIVER
OR WALL SWITCH
WIRING
ROMEX CABLE
Figure 21
Page 25