Empire Comfort Systems DVLXG75BP90N-1 Installer's Manual page 66

Cleaning the Fuelbed and the Glass
Clean the glass periodically. We recommend gas fireplace glass
cleaner.
During start-up, condensation forms on the inside of the glass
causing lint, dust and other airborne particles to cling to the glass.
Also initial paint curing may deposit a film on the glass. Allow the
fireplace to cool and then clean the glass two or three times with
gas fireplace glass cleaner or a non-abrasive household cleaner and
warm water. After that, clean the glass two or three times during
each heating season or more often if necessary.
Clean glass with cleaner designed for fireplaces.
Do not use ammonia based or abrasive cleaners on glass. Do not
attempt to clean glass when glass is hot.
1. Avoid breaking the glass.
2. Do not operate this appliance without the glass or with
broken glass. Have a qualified service person replace
damaged glass and gasket using materials specified by
Empire Comfort Systems.
3. Do not abuse or strike the glass.
4. The use of substitute glass will void all product
warranties.
Do not operate the appliance with the glass removed,
cracked, or broken.
To remove the glass for cleaning, follow the instructions shown
here.
1. Put suction cups on the outer glass.
2. Loosen the five (5) 1/4 turn fasteners.
66
MAINTENANCE AND SERVICE
WARNING
WARNING
WARNING
3. Lift the glass up and tilt the bottom of the glass out.
4. Remove the glass from the fireplace and set to the side.
Be aware that if soot is present on the glass it may stain
carpet or furnishings.
5. Remove the fuel bed on the secondary infill.
6. Remove the four (4) screws securing the infill and take
the infill out.