Empire Comfort Systems DVLXG75BP90N-1 Installer's Manual page 69

Replacing a Remote Control
If the wireless control becomes lost or damaged, a new one can
be ordered from any Empire Comfort Systems Dealer. When
you have the new remote, the following procedure needs to be
followed to pair the remote with the fireplace.
1. Press remote sync button on the fireplace.
2. Press the ON button on remote transmitter. An audible
four beeps will be heard.
3. Remove the cover and replace existing batteries with
three AAA batteries.
4. Replace cover.
Replacing the Burners
Remove the primary and secondary glass using the previous
section. Remove all components of the fuelbed, taking care not
to damage any fuelbed media.
Remove the infill by unscrewing the four screws, lift it from the
firebox by lifting one end up into the top corner and then out
towards you. Take care not to scratch the firebox paint.
Lift out the burners and replace as necessary.
MAINTENANCE AND SERVICE
Serial Number
The serial number is located on the date plate beneath the
engine of the fireplace.
Removing the Control Tray
With the glass, infill, and burners removed, remove the eight
screws from the control tray, shaded gray below. Lift the
control tray partway out of the fireplace and rest it on the
base. Then disconnect the gas and electrical connections to
allow the control tray to be removed entirely.
Replacing the Thermal Cut Out (TCO)
With the glass, infill, and burners removed, remove the
mirrored panel shown in the diagram below. Carefully remove
the panel from the firebox by pushing upwards to unhook
before lifting out.
69