Empire Comfort Systems DVLXG75BP90N-1 Installer's Manual page 11

INSTALLATION CONSIDERATIONS
• Gas supply piping – See page 20.
• Electrical supply and connections 120V, 60Hz, 4 Amp,
right, left or both side entrances - See page 22.
• Allowable fireplace mounting surfaces:
1. A hard, flat, combustible or non-combustible surface
2. A raised platform of combustible or non-combustible
material.
3. The four corners of the fireplace on non-combustible
material – such as cinder blocks (where allowed by local
codes) – so that contact is made on all four perimeter
edges on the bottom of the fireplace.
• If the fireplace is installed directly on carpeting, tile or other
combustible material other than wood flooring, install a metal
or wood panel underneath extending the full width and depth
of the fireplace.
• This fireplace is designed to be installed in a zero-clearance
enclosure. Combustible material can come in contact with
the side standoff spacers, and the fireplace can be secured
to combustible framing with the framing brackets provided.
PLANNING THE INSTALLATION
1. Read the safety information on pages 3 - 7.
2. Check the sticker located on the front page of this instruction
manual is present and matches the relevant information found on
the data plate regarding model type and serial number.
3. Show the homeowner where the rating plate and lighting
instruction plate are located.
4. Install the venting. See page 27 to page 36.
5. Install the ducting. See page 37 to page 42
6. Install and connect the gas lines. See page 20 and page
21.
7. Install the wiring. See page 22.
8. Remove the barrier assemblies. See page 65 to page 67.
9. Install the glass or log set, and rock wool. See their manuals.
10. Sync the remote. See page 51.
11. Adjust the rock wool for perfect burn.
12. Troubleshoot any issues. See page 59 - page 60.
13. Reinstall the barrier assembly.
14. Show the homeowner how to operate the fireplace insert.
15. Show the homeowner how do the basic maintenance.
16. Instruct the homeowner to never attempt to adjust the air
shutters or damper.
BEFORE YOU START (CONT'D)
ACCESSORIES
Accessories for this appliance may be installed prior to or after
fitting the fireplace into the framed opening.
WARRANTY REQUIREMENTS
Any alteration of the original design, installed other than as
shown in these instructions or use with a type of gas not shown
on the rating plate is the responsibility of the person and
company making the change.
The warranty will be voided by, and the warranter disclaims any
responsibility for the following actions:
• Installation of any damaged fireplace insert or vent system
component.
• Modification of the fireplace insert or direct vent system.
• Installation other than as instructed by Empire Comfort
Systems, Inc.
• Improper positioning of the logs or glass door assembly.
• Installation and/or use of any component part not
manufactured or approved by manufacturer.
11