Conducting Ir Hotsync Operations; Preparing Your Computer For Infrared Communication - Palm Tungsten Tungsten C Handbook

Conducting IR HotSync operations

You can use the infrared (IR) port on your handheld to perform HotSync
operations. When you perform an IR HotSync operation, you don't need your
cradle/cable. However, you must have a computer that's equipped with an IR port
and that supports the IrCOMM implementation of the Infrared Data Association
(IrDA) standards. This is especially useful if you travel with an infrared-enabled
laptop. You simply enable infrared communication on your laptop and handheld
and follow the steps in

Preparing your computer for infrared communication

Before you can perform a HotSync operation using the IR port, the computer with
which you want to synchronize must fulfill these requirements:
Your computer must support the IrCOMM implementation of the IrDA
standards.
Your computer must have an enabled infrared port that's built into the
computer, or an enabled infrared device attached to the computer.
Some desktop computers may require an infrared device attached to a physical
COM port. Laptops are likely to have a built-in IR port, so no external device is
necessary.
Your computer must have an installed infrared driver.
If you have an external infrared device attached to your computer, a driver is
probably included with the device. Consult the documentation included with
the device for information on installing the required driver.
Check your computer's documentation to learn if the computer supports infrared
communication.
To configure HotSync Manager for infrared communication on a Windows computer:
Click the HotSync Manager icon
that Infrared is checked.
– If you have an Infrared option on the HotSync Manager menu, and that
option is selected, skip to
– If you do not have an Infrared option on the HotSync Manager menu,
complete the following steps:
a.
b.
"Performing an IR HotSync operation"
Make sure that Local Serial is selected on the menu.
From the HotSync Manager menu, select Setup.
Conducting IR HotSync operations
in the Windows system tray, and make sure
"Performing an IR HotSync operation."
later in this section.
317