Performing An Ir Hotsync Operation; Returning To Cradle/Cable Hotsync Operations - Palm Tungsten Tungsten C Handbook

Performing an IR HotSync operation

After you complete the steps to prepare for performing an IR HotSync operation,
it's easy to perform the actual operation.
To perform an IR HotSync operation:
Press Home
1.
Tap the HotSync icon
2.
Tap Local.
3.
Tap the pick list below the HotSync icon and select IR to PC/Handheld.
4.
Position the IR port of your handheld within a couple of inches of the infrared
5.
port of your computer.
Tap the HotSync icon to start the IR HotSync operation.
6.

Returning to cradle/cable HotSync operations

It's easy to return to using the cradle/cable for HotSync operations.
If your cradle/cable is connected to a USB port, you can continue using it while
HotSync Manager is configured for infrared communication. Use the following
instructions to return to local USB cradle/cable HotSync operations only when
necessary, such as when you have disconnected the cradle/cable from the
USB port.
.
.
Tap here
Select IR to PC/Handheld
Tap here to start IR
HotSync operation
Conducting IR HotSync operations
319