Other Applications - Palm Tungsten Tungsten C Handbook

Select any of the following preferences:
5.
Enable Smart
Addressing
Auto-Empty Mail
from Trash
Timeout
Auto-Disconnect
Disconnect on
Exit
Modem Wait
Cutting and copying text from an e-mail message for use in other applications
You can copy any text from an e-mail message, either from one you have composed
or have read or from an attachment you have downloaded and opened (such as a
Word doc), for use elsewhere in the VersaMail application or in another
application. Text you can select and copy includes:
A name
An e-mail address
Body text of an e-mail message or a downloaded attachment
Types ahead and completes a recognized e-mail address. See
the procedure for creating new e-mail later in this chapter for
more information.
Determines how often e-mail messages in the trash are
automatically deleted. See
this chapter for more information.
Sets the number of seconds to try to connect before timing
out. This value can be any number greater than 0 seconds;
however, if you set the number too low, your connection
attempt may time out before you make a connection with the
e-mail service provider.
The default setting is 45 seconds. To change, tap the Timeout
field and enter a new value.
Automatically disconnects your remote connections after
each command. Each command you perform initiates a new
call to your ISP. This setting is not recommended if you plan
to perform multiple e-mail transactions in a short amount of
time.
Disconnects from the network only after you leave the
VersaMail application. This feature is an alternative to
Auto-Disconnect. This option keeps your connection active
while you perform multiple transactions in the VersaMail
application, but automatically disconnects when you move
on to a different application on your handheld. If this option
is not selected, you must manually disconnect from your ISP.
Displays the number of seconds that the modem uses to
initialize itself. If you have a modem, tap and enter a number
of seconds for the wait. The typical setting for a wireless
modem is 3, and the typical setting for most normal modems
is 0.
Going beyond the basics
"Emptying the trash" earlier in
261