Preparing to use your handheld
Before you begin using your handheld and Palm Desktop software,
you must complete a few easy installation tasks.
Connecting the HotSync cradle
Important: The HotSync cradle supplied with your handheld fits a
USB connector. If your computer does not have a USB
port, or if you are using Windows 95, Windows NT, or an
older Macintosh, you can order a serial cradle and either
a 25-pin or Macintosh serial adapter, if necessary, from
http://www.palm.com
accompanies the serial cradle before attempting to
complete the installation tasks.
1. Shut down and turn off your computer.
2. Plug the USB connector into a USB port on your computer.
3. Connect the power cord that attaches to the back of the cradle's
USB port connector to the AC adapter cord.
4. Plug the AC adapter into any AC current outlet.
Charging your handheld
Just place your handheld in the cradle for two hours for an initial
charge before you use it. Then place it in the cradle for a few minutes
each day to recharge the battery to full capacity. If your handheld
shuts down because the battery has fully discharged, you still have
about a week to recharge the battery before you lose the data on your
Chapter 1
. Follow the documentation that
Page 3