Battery Considerations; Resetting Your Handheld; Performing A Soft Reset - Palm Tungsten Tungsten C Handbook

Palm tungsten tungsten c: user guide
Hide thumbs Also See for Tungsten Tungsten C:
Table of Contents

Advertisement

Appendix A Maintaining Your Handheld

Battery considerations

Please note the following considerations for the battery in your handheld:
Under normal conditions, you can keep your handheld battery charged by
placing it in the cradle between 15 to 30 minutes each day. You can conserve
battery life by changing the Auto-off setting that automatically turns the
handheld off after a period of inactivity and by selecting the Conserve power
option in the Wi-Fi preferences. See
see
If the battery becomes low in the course of normal use, an alert appears on the
handheld screen describing the low battery condition. If this alert appears,
perform a HotSync
in the cradle to recharge the unit. This helps prevent accidental data loss.
If the battery becomes too low, the wireless operations are disabled to save
battery strength.
If the battery drains to the point where your handheld does not operate, it stores
your data safely for about five days. In this case, there is enough residual energy
in the battery to store the data, but not enough to turn on your handheld. If your
handheld does not turn on when you press the power button, you should
recharge the unit immediately. The battery may not have enough residual
energy to power the indicator light, which normally displays green when
charging.
If your battery drains and you have the unit in an uncharged state for an
extended period of time, you can lose all of the stored data.
There are no serviceable parts inside your handheld, so do not attempt to open
the unit.
If you ever dispose of your handheld, please dispose of it without damaging the
environment. Take your handheld to your nearest environmental recycling
center.

Resetting your handheld

Under normal circumstances, you will not have to use the reset button. On rare
occasions, however, your handheld may no longer respond to buttons or to the
screen. In this case, you need to perform a reset to get your handheld running
again.

Performing a soft reset

A soft reset tells your handheld to stop what it's doing and start over again. All
records and entries stored in your handheld are retained with a soft reset. After a
soft reset, the Welcome screen appears, followed by the Date and Time Preferences
screen (to set the date and the time).
386
"Wi-Fi preferences"
in
®
operation to back up your data; then leave your handheld
"Auto-off delay"
Chapter 18
for more information.
in
Chapter 18
and

Advertisement

Table of Contents
loading

This manual is also suitable for:

P80900us - tungsten c - os 5.2.1 400 mhzTungsten c

Table of Contents