Table of Contents
Advertisement
I tried to perform a local
HotSync operation, but it did
not complete successfully
(Continued)
If you are using the serial cradle/cable, try a lower baud
rate setting on the Local tab in the Setup dialog box.
If you are using the serial cradle/cable, make sure you
aren't running a program, such as America Online, that
uses the serial port you selected in the Setup dialog box.
On a Mac computer, try each step in turn:
Make sure HotSync Manager is enabled on the HotSync
Controls tab in the HotSync Software Setup window.
If you are using the optional serial cradle/cable,
double-click the HotSync Manager icon in the Palm folder
and then click the Connection Settings tab. Make sure the
port selection matches the port where your HotSync
cradle/cable is attached.
If you are using the optional serial cradle/cable, try a lower
Speed setting on the Connection Settings tab.
If you are using the optional serial cradle/cable, make sure
you aren't running a program, such as America Online, fax
or telephony software, or AppleTalk networking, that uses
the serial port you selected in the Connection Settings tab.
HotSync problems
399
Advertisement
Table of Contents
