Printing Measurement Data; Disconnecting From The Printer - Konica Minolta CR-10 Plus Instruction Manual

Connecting a Printer

Printing Measurement Data

This function can be used to print measurement data.
The instrument must be connected to the printer in advance. See page E-73 "Connecting
a Printer" for details on connecting the instrument to a printer.
Notes • Printing is not possible if the connection is not correct.
• Do not disconnect the cable while printing. Failure to do so may cause a
malfunction.
Setting Procedure
❶
Connect the instrument to the printer and enable
communication.
❷
Press  "Back" from the <MENU> screen to go to the
measurement screen.
❸
The target or the sample will be measured.
❹
The measurement results will be displayed on the instrument's LCD screen
and at the same time the printer will begin printing.
Print Sample
Serial No.
Instrument name display
Target data display
Sample data display
(Cont.)

Disconnecting from the Printer

❶
❷
10:00
Target
❸
87.9
L*
-0.6
a*
Notes
b * 2.9
❹
( "
[First measurement]
[Second measurement]
Disconnect the printer from the instrument.
MENU/OK
Press , move the selection frame to "USB
Connec." using either or , and then press
MENU/OK
.
Move the selection frame to "Disconnect" using either
MENU/OK
or , and then press
To print again, turn the printer OFF once, and
reconnect the printer from the fi rst step.
Click  "Back" to go back to the <MENU> screen.
Ver.1.00.0000
MENU
Back
Browse Data
Language
Avg. Meas.
Tol. Judg.
Mask Setting
Auto Off
Preset
Date/Time
USB Connec.
10:00
MENU
.
Back
USB Connec.
Disconnect
PC
Printer
or
L*a*b*
tolerance, "[ ]" will be
values judged as NG.
74