Table of Contents
Advertisement
INSTALLATION PROCEDURE
!2 S tring the control panel lead wire through the hexagonal hole in the switch box(notch facing down)
so that the control panel is protruding out of the hole.
Approx. 20cm of play
!3 S tring the connector end of the lead wire through the hexagonal hole in the film insertion table for
the control panel and the notch provided. Make sure you have about 20cm of play in the wire.
!4 N ow bring the film insertion table up against the SRX-101A main unit, and string the connector end
of the lead wire through the elongated hole in the main unit until the connector is hanging in front of
the CPU board. At this point, fix the film insertion table to the main unit with the screw provided.
!5 R econnect the lead wire to the CPU board and fix the ground wire terminal with a screw. Make sure
that there is enough play in the wire so that the CPU board is not being pulled or strained.
!6 A ttach the control panel switch box to a convenient place on the light shield panel.
Note : The control panel may also be attached directly to either the left or right side of the film
insertion table, though it will not be easily seen.
!7 A ttach Packing(G) to the right and left hand sides of the outer cover of the electrical components as
shown in the diagram below.
SERVICE MANUAL
94
Notch
Insertion Table
Electrical Components Unit Outer Cover
Packing(G)
Hexagonal hole
Lead Wire
Notch
Packing(G)
Control Panel
Switch Box
Advertisement
Chapters
Table of Contents
