Table of Contents
Advertisement
12-3. Package Contents Verification
Before installing the SRX-101A, make sure to check the main unit and accessory equipment
for any missing parts or damage during transportation.
(1) Check to see if the model name and numbers printed on the outside of the package
correspond to what the customer ordered.
(2) Check if there is any extraordinary damage to the outside of the package.
(3) Open the package while following the precautions outline in the next section.
(4) Check if there is any missing parts by matching the contents of the package with the
packing list provided.
(5) Check all the parts for any external damage.
NOTE :
If there are any missing parts or damage, notify your local KONICA representative immediately.
12-4. Precautions ti Take When Opening the Package
(1) At least two persons are needed to hand-carry the SRX-101A.
(2) Be careful when cutting the bands away from the package. They have been bound tightly
and could cause injury when released.
(3) The racks have been wrapped in plastic sheets.
There is cushioning material between the racks and processing tanks.
Remove carefully and dispose of all these materials before beginning installation.
12-5. Opening the Package
(1) Use scissors to cut the bands.
(2) Cut the top of the outer crate open with a utility knife.
(3) Lift the box of accessories up and out over the top of the crate. This package contains the
replenisher tank and other accessories.
(4) Lift the outer crate up and over the main unit.
(5) Remove the Feed Tray.
(6) Unload the Main Unit from the pallet.
At least two persons are necessary to lift and transport the processor.
PRE-INSTALLATION INSTRUCTIONS
SERVICE MANUAL
65
Advertisement
Chapters
Table of Contents
