Table of Contents
Advertisement
CHANGING PROCESSING CONDITIONS
14. Changing Processing Conditions
The following listing indicates the conditions that were preset at the factory.
When any changing is needed or customer asks to do that, refer to the following listing.
Condition
Process Cycle Time
DEV Temperature
DRY Temperature
DEV
Replenish
Amounts
FIX
Standby Time
Frequency
NOTE :
1. There are three process cycle times to choose from : 90, 120, and 180 sec.
2. The developer temperature may be set between 29: and 37:.
3. The drying temperature (the heater surface temperature) may be set between 210: and 250:.
Adjustments in temperatures are made necessary by differences in room conditions around the
processor.
4. Replenish amounts may be adjusted to –20%, –40%, or +30% of the preset values.
5. There are three standby times to choose from : 10 min, 30min, and 0 min (continuous operation).
If no film enters the processor for 1 hour from READY for processing (READY Lamp ON), the
SRX-101A will automatically switch over the standby mode, during which the drying heater will
be switched OFF and ON at 5 minutes intervals.
As soon as a sheet of film enters the processor, the SRX-101A will automatically switch from
standby into the normal operation mode.
6. The following table shows the standard developer temperature levels for each processing
cycle time.
Cycle Time (sec.) DEV Temperature (:)
90
120
180
SERVICE MANUAL
82
Factory Setting
120 Sec.
34:
230:
40P/24 x 30cm(10 x 12inch)
70P/24 x 30cm(10 x 12inch)
10 min.
50/60 Hz
36
34
(for mammography)
Change Procedure
Set DIPSW1-3,4 according to the table on p 46.
Adjust the volume on the temperature control board.
See p 51.
Set DIPSW1-7,8 according to the table on p 46.
Set DIPSW1-5,6 according to the table on p 46.
Set DIPSW1-2 according to the table on p 46.
Advertisement
Chapters
Table of Contents
