Nortel Digital Telephone IP Adapter Installation And Administration Manual page 78

Installing the Digital Telephone IP Adapter unit
Complete the following procedure:
1 Choose the location on the wall where you want to mount the Digital
Telephone External IP Adapter unit.
2 Use the pre-drilled screw slots on the bottom of the Digital Telephone
External IP Adapter unit as a guide to measure and mark the location on
the wall for each mounting screw.
The measurements between the screw slots are as follows:
from front to back panels: 2.54 cm (1 in.)
from side to side: 15.8 cm (6.25 in.)
3 Mount the screws.
Note: Do not screw the screws all the way in. Stop when the heads are
about 5 mm (1/8 inch) from the wall.
4 Mount the Digital Telephone External IP Adapter unit on the screws, then
gently pull it down so the screws slide into the narrow portion of the screw
slots.
Note:
5 Make sure that the Digital Telephone External IP Adapter unit is securely
mounted.
.
54
Do not let go yet.
WARNING
Risk of equipment damage
Ensure that you fasten the
unit securely to the wall. Falls can damage the unit.
Digital Telephone IP Adapter Installation and Administration Guide
Digital Telephone External IP Adapter
Standard 3.0