Restarting The System; When To Perform A Restart - Nortel Digital Telephone IP Adapter Installation And Administration Manual

Administration

Restarting the system

After a firmware upgrade or a configuration change, it is often necessary to
restart the Digital Telephone IP Adapter unit. Use the following procedure to
restart the unit using Configuration Manager.
Note: After you restart the system, wait 7–10 seconds before placing a call.
Getting there
911x

When to perform a restart

Each time that you make a configuration change, perform a Save to Flash. You
must also restart the unit if Configuration Manager prompts you to do so.
Note: When you save configuration changes to Flash, the system suspends new
call processing for approximately 30 seconds. Some configuration changes do
not take effect until the unit has been re-started.
Restarting the unit
To restart the unit:
1 From the Menu Bar, choose Connect
Result: The System Restart dialog box displays, similar to the following:
2 Click the Yes button.
Result: The Restarting the System. Please Wait.....progress bar displays
indicating that Configuration Manager is restarting the system, similar to the
following:
180
→
Configuration Manager
Digital Telephone IP Adapter Installation and Administration Guide
→ →
System Reset
Standard 3.0
Restart.