Nortel Digital Telephone IP Adapter Installation And Administration Manual page 118

Changing configuration settings using Configuration Manager
911x System Configuration field descriptions
Field
Unit ID
Node Name
DSP Gain
Time Offset
Emergency Feature
94
Description
Enter a unique number from 1 through 20 to identify
the Digital Telephone IP Adapter unit that you are
configuring and differentiate it between the RLC,
Remote Gateway 9150 unit, and all other remote units
connected to the same RLC. This number:
must be different from numbers assigned to other
units connected to the same RLC
must be consistent with the configuration on the
RLC for this unit ID
The default is 1.
Enter your site name.
The node name identifies this Digital Telephone IP
Adapter unit in the remote network.
The default is 911x.
Select the number of decibels (dB) that you want to
add to, or subtract from, the strength of the transmitted
signal before the DSP processes it.
Valid options are 9, 6, 3, 0, -3, -6, -9, -12, and -15.
The default is 0 dB.
Note: Change this setting at the remote site to address
a problem with signal strength at the host site.
Click on the up or down arrows to change the time
zone difference from the host PBX.
The default is 0:00 (0 hours and 0 minutes).
Note: The time can be changed in 15-minute intervals
only.
This setting does not apply to Digital Telephone IP
Adapters.
Digital Telephone IP Adapter Installation and Administration Guide
Standard 3.0