Nortel Digital Telephone IP Adapter Installation And Administration Manual page 72

Installing the Digital Telephone IP Adapter unit
3 Use both hands to push forward until the circuit card snaps into place under
the brackets.
Note: Two holes on either side of the circuit card are now aligned with the
corresponding holes on the footstand.
4 Attach the Digital Telephone Internal IP Adapter circuit card to the footstand
with the screws supplied in the Installation Kit.
Note: Refer to "D" in the diagram on page 48.
5 Plug the male RJ-11 connector on the loose end of the Meridian Line Cord
attached to the Digital Telephone Internal IP Adapter circuit card into the
jack on the telephone.
6 Re-attach the footstand to the bottom of the telephone.
7 Apply the overlay identifying the power connection and the jack connecting
your Ethernet for IP network connectivity.
48
C
circuit card
D
Digital Telephone IP Adapter Installation and Administration Guide
Standard 3.0
G101493