Before You Begin - Nortel Digital Telephone IP Adapter Installation And Administration Manual

Changing configuration settings using Configuration Manager

Before you begin

This section describes the configuration settings that apply to Digital Telephone
IP Adapter units. If you need remote serial access to Configuration Manager, use
a remote management software application.
Note: Nortel recommends that you use the telephone set menu to perform the
initial configuration for the Digital Telephone IP Adapter unit. Refer to Chapter
4, "Configuring the IP Adapter unit using the telephone menu." Once
configured, you can then use the Configuration Manager for changes,
administration, and firmware upgrades. For a more detailed description of
Configuration Manager, refer to the Reach Line Card Installation and
Administration Guide (NTP 555-8421-210).
ATTENTION!
90
After initial configuration with the telephone set menu,
complete all Digital Telephone IP Adapter configuration
using Configuration Manager. Use the man-machine
interface (MMI) only with the assistance of technical
support personnel for troubleshooting and diagnostic
testing.
Digital Telephone IP Adapter Installation and Administration Guide
Standard 3.0