Table of Contents
Advertisement
Page 28 of 84
Installing the Agent Greeting Card
Caution: An EMC Shielding kit (ferrite- A08070556) must be installed on the
Nortel Networks Server Subnet interface cable to meet regulatory requirements at
the installation site. The ferrite must be placed on the Ethernet cable during
installation. Cable ties are then placed to retain the ferrite in the correct position.
This applies to small and large systems.
RS232 maintenance port
The RS232 maintenance port provides access to the Media Card Agent Greeting
(NTVQ09BA) command prompt for monitoring and maintenance purposes such as
upgrades and debugging. This port is available at the 9-pin connector on the Media
Card Adapter CLAN and also at the mini-DIN socket on the faceplate of the Media
Card (NTVQ09BA). The serial port settings are 9600 baud, 8 data bits, 1 stop bit,
no parity and no flow controls.
Note: The maintenance port should only be accessed by one of the above
connections at any one time.
NTPH13AA_Install
Figure 3:Media Card Agent Greeting Card Adapter (L-Adapter)
3.02 September 2006
Advertisement
Table of Contents
