Table of Contents
Advertisement
Page 26 of 84
Installing the Agent Greeting Card
Cabling the VPS Agent Greeting Card (NTVQ09AB)
The following cables are required for cabling the VPS version of the Agent
Greeting card:
See "Large System Cabling" on page 29 for details on the large system cabling of
an Agent Greeting card.
Ethernet and Serial Port Interfaces on the VPS Agent Greeting Card
(NTVQ09AB)
The NTMF94BA cable breaks the backplane signals out into an Ethernet port
(10-Base-T) and a serial RS-232 port. This is the same RS-232 port that is presented
to the faceplate Mini-DIN connector.
The Ethernet port on the NTMF94BA has a single female RJ45 connection, so that
a standard 10-Base-T Ethernet cable can be used to connect it to the LAN/hub.
Cabling the Media Card Agent Greeting Card (NTVQ09BA)
The following cables are required for cabling the Media Card (NTVQ09BA)
version of the Agent Greeting card:
NTPH13AA_Install
•
NTAG81CA Maintenance cable for Agent Greeting card
•
NT8D81AA Backplane to I/O panel cable (Option 51C to 81C only -
before IPE shelf vintage NT8D37EC).
•
NTMF94BA RJ45 Octopus cable (provides Ethernet port and
Debug/Maintenance RS-232 port).
•
(1) Category 5, 10-Base-T Ethernet standard cable.
Caution
Do not connect terminal equipment to both the Backplane
!
Serial Connector on NTMF94BA and the Faceplate
Serial Connector on NTAG81CA. These are physical
cabling options for the same serial port.
•
A0852632 L-Adapter (Shielded 50 pin key telephone to 9D Sub & Twin
RJ45 Adapter)
3.02 September 2006
Advertisement
Table of Contents
