Callpilot System Setup; Nortel Callpilot; Meridian Mail To Callpilot Migration Utility Guide; Nn44200-502 01.02 Standard - Nortel Meridian Mail Utility Manual

Comparison issue

CallPilot system setup

Introduction
The CallPilot setup is different from the Meridian Mail setup. A CallPilot
system has three layers:
•
•
•
All three layers are required for CallPilot to take calls. You must set up and
configure each layer individually.
Required documentation
Refer to the CallPilot documents listed in
migration process" (page
installation.
Also refer to the most recent version of the Distributor Technical References
(DTR). To obtain the most recent DTR, refer to the Nortel Partner
Information Center (PIC) at
http://www.nortel.com/pic
To access the PIC, you must be a registered Nortel distributor.
Sample hardware setup
The diagrams on pages
with Meridian 1" (page 128)
with Communications Server 1000" (page 129)
setup for the Meridian 1 and Communications Server 1000 systems.
A Web browser must be installed on a PC that has IP connectivity to the
CallPilot server. Use the Web browser to connect to the CallPilot Manager
Web server, and then to log in to the CallPilot server and administer the
system.
The CallPilot server is shipped from the factory with the CallPilot Manager
Web server already installed. To install the CallPilot Manager Web server on
a stand-alone server, refer to the Software Administration and Maintenance
guide (NN44200-600).
Copyright © 2007, Nortel Networks
.
Meridian Mail
server hardware/software layer
Windows Server 2003 layer
CallPilot application layer

Nortel CallPilot

Meridian Mail to CallPilot Migration Utility Guide

NN44200-502 01.02 Standard

5.0 17 April 2007
Chapter 2 "Understanding the
11), for information on completing a CallPilot
"Sample network setup: tower or rackmount server
through "Sample network setup: 201i server
CallPilot system setup 127
CallPilot
show the CallPilot network