Nortel CallPilot Installation Manual page 34

34 Chapter 4 Installing the server and peripheral devices
1
2
3
4
5
6
7
Copyright © 2007, Nortel Networks
.
Set the SCSI ID dial switch on the tape drive to SCSI ID 6.
With the power switch off, connect the external SCSI tape drive to
the port labeled N on the rear panel. See
(page 31).
Plug the tape drive into the same single-point ground and A/C power
as the rest of the system.
Power on the tape unit.
SLR75 tape drive installed on 1005r
The tape drive is plug-and-play and the required drivers are already
installed on your system.
You must run the device scan initiation in device manager to detect
the drive.
a. Choose Start → My Computer →Properties →Hardware →
Device Manager from the desktop.
b. Select Action → Scan for Hardware changes.
The tape drive is ready for use.
Nortel CallPilot
1005r Server Hardware Installation
NN44200-308 01.04 Standard
5.0 30 April 2007
"Rear panel connectors"
—End—