Inspecting The Modem; Connecting Peripherals To The Server - Nortel CallPilot Installation Manual

•
For more information about the High Availability feature, see High
Availability: Installation and Configuration (NN44200-311).

Inspecting the modem

Introduction
You require a modem to support remote dial-up access to the CallPilot
server. Nortel technical support also connects to your CallPilot server for
troubleshooting purposes. Nortel connects to your server only when you
request technical assistance.
Required equipment
To install the modem, you need the following equipment:
•
•
•
•
Serial port modems with RS-232 connections are not supported on the
1005r.
What is next?
Continue with

Connecting peripherals to the server

Rear panel connectors
The following diagram shows the connectors on the rear panel.
Copyright © 2007, Nortel Networks
.
The two servers are delivered with only one dongle. It does not matter
which server you connect the dongle to until you configure the servers.
USB modem
RJ-11 analog phone cord
USB cable (supplied with the modem)
analog line jack
"Connecting peripherals to the server" (page
Nortel CallPilot
1005r Server Hardware Installation
NN44200-308 01.04 Standard
5.0 30 April 2007
Connecting peripherals to the server 31
31).