Network Connectivity - Nortel CallPilot Installation Manual

When looking at the server from the rear (see
features" (page
the top down.
You must connect the DS30X-1 cable to an MGate card to receive the clock
source for the MPB96 board. Failure to connect the DS30X-1 cable to an MGate
card can result in noise interference on the remaining voice channels.
Table 1
1005r PCI card slot configurations
Configuration
Single MPB96
Three MPB96
(High Capacity)
Note: 3 Mgate cards connect to 1 MPB96

Network connectivity

Introduction
This section describes how the 1005r server can be integrated into your
network. The integration depends on the type of switch you are using.
To secure the CallPilot server from unauthorized access, ensure that the CallPilot
network is inside your organization's firewall.
Sample network setup: Meridian 1
The following diagram shows a CallPilot server sample network setup with a
Meridian 1 switch. The Meridian 1 switch can be one of the following:
•
Copyright © 2007, Nortel Networks
.
13)), both full-size and low-profile cards are numbered from
Card
slot Slot
type number
Full size FS_PCI-1
FS_PCI-2
FS_PCI-3
Low profile LP_PCI-1
LP_PCI-2
LP_PCI-3
Full size FS_PCI-1
FS_PCI-2
FS_PCI-3
Low profile LP_PCI-1
LP_PCI-2
LP_PCI-3
Option 11C or Option 11C Mini
Nortel CallPilot
1005r Server Hardware Installation
NN44200-308 01.04 Standard
5.0 30 April 2007
"Back panel controls and
ATTENTION
Position Card type
top
MPB96
middle Not used
bottom Not used
top
RAID
middle Dual NIC
bottom Dual NIC
top
MPB96
middle MPB96
bottom MPB96
top RAID
middle Dual NIC
bottom Dual NIC
ATTENTION
Network connectivity 17
Meridian 1*/
CS* 1000
MGate 1, 2, 3
MGate 1, 2, 3
MGate 4, 5, 6