The front bezel covers the electrostatic discharge (ESD) connection, both
hard drives, and the DVD/CD/CDRW drive pull handle. The control panel,
USB port 2, and the front comm 2 serial port connection are not covered by
the front bezel.
To remove the front bezel
Step
1
2
3
Copyright © 2007, Nortel Networks
.
Action
CAUTION
Risk of equipment damage
Do not attempt to move or lift the server before removing the front
bezel; the server can disengage from the bezel and fall.
Loosen the two black captive fasteners on either side of the front
bezel.
Pull the front bezel off the front panel by the captive fasteners.
Do not touch components on the front panel without ESD protection.
Attach an ESD strap to your wrist and connect it to a single point
ground connection.
Nortel CallPilot
1005r Server Hardware Installation
NN44200-308 01.04 Standard
5.0 30 April 2007
Removing the front bezel 27
—End—