Nortel CallPilot Installation Manual page 33

3
4
5
6
To connect the modem to the server
Step
1
2
3
4
5
To connect the external SCSI tape drive
Step
Note : The external SCSI tape drive is a plug and play device. For a High
availability system you may wish to share one tape drive between the two
servers.
Copyright © 2007, Nortel Networks
.
Plug the monitor into the video connector on the rear panel. Tighten
the screws on the connector.
Ensure that a single-point ground reference is available for all
the power outlets serving the CallPilot server and its peripherals.
Before the CallPilot server installation, a qualified electrician must
implement the single-point ground reference requirement between
the power outlets of the CallPilot server and the power outlets of
the switch.
Connect the power cord to the monitor and plug the other end into
a wall receptacle or power bar.
Turn on the monitor.
Action
Connect one end of the telephone cable to the modem RJ-11 jack
labeled LINE.
Connect the other end of the telephone cable to the RJ-11 jack in
the wall.
Connect one end of the USB cable into the modem.
Connect the other end of the USB cable into either USB port 1 on the
rear panel (long term) or USB port 2 on the front panel (short term).
Ensure that a single-point ground reference is available for all
the power outlets serving the CallPilot server and its peripherals.
Before the CallPilot server installation, a qualified electrician must
implement the single-point ground reference requirement between
the power outlets of the CallPilot server and the power outlets of
the switch.
Action
Nortel CallPilot
1005r Server Hardware Installation
NN44200-308 01.04 Standard
5.0 30 April 2007
Connecting peripherals to the server 33
—End—
—End—