Nortel CallPilot Installation Manual page 24

24 Chapter 3 Preparing for installation
Step Description
2 Unpack the server, and ensure you have all the items you need (see
"Unpacking the 1005r server" (page
Complete the following checklists that are provided in the Installation
and Configuration Task List (NN44200-306):
• "CallPilot software media and documentation checklist"
• "CallPilot server hardware checklist"
3
Remove the front bezel and inspect the front panel (see pages
"Removing the front bezel" (page
4
Place the 1005r server in the chosen location (see
server" (page
5
Replace the front bezel (see page
30)).
6
Connect the 1005r server and devices as follows:
•
Connect the monitor, keyboard, and mouse (see
peripherals to the server" (page
•
Connect the modem (see
(page
•
Connect the 1005r server to the ELAN Ethernet switch or hub
(Meridian 1 or CS 1000 only) (see
the ELAN subnet" (page
Note: If you are connecting the optional Nortel server subnet, do not
power up unless your antivirus programs and Nortel security updates
are installed first.
•
Connect the 1005r server to the Nortel server subnet Ethernet
switch or hub (optional) (see
Nortel server subnet (optional)" (page
Copyright © 2007, Nortel Networks
.
29)).
33)).
To comply with EMC radiation requirements, a Class A
Ethernet switch or hub must be located 10 m (33 ft.) away from
the 1005r server. Shielded Ethernet cables must be used.
Nortel CallPilot
1005r Server Hardware Installation
NN44200-308 01.04 Standard
5.0 30 April 2007
25)).
26)).
"To replace the front bezel" (page
31)).
"To connect the modem to the server"
"Connecting the server to
35)).
ATTENTION
"Connecting the server to the
36)).
"Installing the
"Connecting
Check