Interpreting The Network And Drive Activity Leds - Nortel CallPilot 202i Maintenance And Diagnostics

20 Chapter 3 Troubleshooting your CallPilot system
Power status LED indications
IF the power
status LED is
On
Off

Interpreting the network and drive activity LEDs

The 202i server provides two LEDs for each RJ45 Ethernet connector
to indicate ELAN Subnet, and Nortel server subnet CLAN activity. They
following diagram shows a close up view of the two RJ45 Ethernet
connectors and the two LEDs for each connector.
Copyright © 2009, Nortel Networks
.
THEN
the server is receiving power from the shelf. It is safe to
remove it from the switch.
Note: When the LED is lit, the HEX display may display
one of the following: T:XX, F:XX, HOST, or DOWN.
Note: You must courtesy down CallPilot, and
then shut down the operating system before you
can remove the 202i server from the switch. For
instructions, see "Powering down the server" in the
CallPilot Installation and Configuration Task List.
NN44200-306.
Nortel CallPilot
202i Server Maintenance and Diagnostics
NN44200-708 01.02 Standard
5.0 11 August 2009
CAUTION
It is not safe to remove the server
from the switch. The server is in one
of the following states:
• The server is in the operating
system startup sequence.
• The server has completed
the startup sequence and is
running.