Gbe Large Module - Nortel Secure 4134 Installation Manual

You must install the Secure Router 4134 PoE power supply to take advantage
of the PoE capabilities.
Table 20
Cable and connectors
Port
10Base-T (full-
or half-duplex),
100Base-TX (full
duplex)
Table 21
Module LEDs
LED
10/100 BASE-T
PORT STATUS

GbE Large Module

The 44-port 10/100/1000 Large Module provides 44 Ethernet ports that
each support 10/100/1000 Mbps operation over unshielded twisted pair
(UTP) wiring, as well as two SFP optical ports. Up to 44 ports can be in
use at one time.
The 44-port GbE Large Module provides both Layer 2 switching and Layer 3
routing functionality.
The following figure shows the 44-port GbE Large Module.
Copyright © 2007, Nortel Networks
.
Connector Recommended
cable type
RJ-45 EIA Category 3,
4, or 5 UTP for 10
Mb/s operation.
EIA Category
5 UTP or STP
required for 100
Mb/s operation.
Description
LEDs are integrated into each port.
Status of each interface:
• Off: Link not connected or Link Fail
• Solid Green: Link established at 10 or 100 Mbps
•
Blinking Green: Receiving/transmitting traffic
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 01.02 Standard
10.0 7 August 2007
Interface modules for the Secure Router 4134 37
ATTENTION
Minimum
cable length
None
Maximum
cable length
328 ft (100 m)