Prerequisites; Installing A Small Module - Nortel Secure 4134 Installation Manual

Slots 1–4 are Small Module slots. Slots 5–7 are Medium Module slots. If
you insert a Large Module, it spans slots 6 and 7. In this case, the Large
Module is identified in the Command Line Interface (CLI) as slot 6.
Average time to install an interface module: 1 minute.

Prerequisites

•

Installing a Small Module

Procedure steps
Step
1
2
3
4
5
Copyright © 2007, Nortel Networks
.
CAUTION
ESD
To prevent damage from electrostatic discharge, always wear an
antistatic wrist strap connected to an ESD jack when working with
interface modules.
CAUTION
Risk of equipment damage
Always handle interface modules by the edges, or by using the
levers, where applicable.
Ensure you have a Phillips #2 screwdriver.
Action
Using a Phillips screwdriver #2, remove the slot cover plate from the
slot in which you are installing the module.
Align the module with the slot and the slot module guides.
Slide the module into the chassis until its connector panel touches
the chassis back panel.
Push gently, but firmly, to seat the connector on the interface module
in the chassis back panel.
Using a Phillips screwdriver, tighten the two captive screws to secure
the module to the chassis.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 01.02 Standard
10.0 7 August 2007
Installing the interface modules 47
—End—