Prerequisites - Nortel Secure 4134 Installation Manual

66 Installing Secure Router 4134 hardware components
The internal Compact Flash that ships with the Secure Router 4134 contains
the system image.

Prerequisites

•
•
Procedure steps
Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
CAUTION
Do not open the Secure Router 4134 service access panel while
the unit is powered.
Ensure you have a replacement Compact Flash ready to install.
Ensure you have a Phillips #2 screwdriver.
Action
Remove the two screws at the rear of the Secure Router 4134 that
hold the service access panel secure. The following figure shows
the two screws that you must remove.
Slowly slide the access panel toward you until it is clear of the
Secure Router 4134.
Locate the internal Compact Flash module.
Firmly grasp the Compact Flash by its edges and pull straight up to
remove it from the slot. See the following figure.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 01.02 Standard
10.0 7 August 2007
ATTENTION