Prerequisites - Nortel Secure 4134 Installation Manual

50 Installing Secure Router 4134 hardware components
You must replace the interface module with a module of the same type as that you
remove. You must insert the replacement module in the same slot from which
you remove the failed interface module.
Traffic on the interface module you are hot swapping is interrupted during
the hot swap procedure. Traffic on other interface modules is unaffected.

Prerequisites

•
•
Procedure steps
Step
1
2
3
4
5
6
7
Copyright © 2007, Nortel Networks
.
You must save your configuration. If you do not save your current
configuration before hot swapping a module, the Secure Router 4134
uses the last saved configuration. To save your configuration, enter
save local.
Ensure you have the replacement interface module ready to install.
Action
To verify that the Secure Router 4134 recognizes the interface
module, enter:
show chassis
Proceed with the hot swap of the interface module if, and only if,
the interface module appears in the list of installed modules on
the Secure Router 4134. If the interface module does not appear
in the list of installed modules, see Nortel Secure Router 4134 —
Troubleshooting (NN47263-700).
To access the configuration mode, enter:
configure terminal
To shut down the interface module, enter:
chassis module <slot> shutdown
To verify the change in status of the module, enter:
show chassis
Remove the interface module from the Secure Router 4134.
Move the cables from the module you removed to the replacement
module.
You must connect each cable in the same port on the replacement
module that the cable occupied in the module you removed.
Insert the replacement interface module in the slot, securing it firmly
with the captive screws.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 01.02 Standard
10.0 7 August 2007
ATTENTION