Prerequisites
•
•
Procedure steps
Step
1
2
3
4
5
Installing or removing the internal VPN/IPSec module
Use the instructions in this section to install, remove, or replace the internal
VPN/IPSec module. This internal module is not hot-swappable.
If you ordered the VPN/IPSec module with your Secure Router 4134, the
Secure Router ships with the VPN/IPSec module installed.
Average time to install the internal VPN/IPSec module: 2 minutes.
Copyright © 2007, Nortel Networks
.
Installing or removing the internal VPN/IPSec module 59
CAUTION
ESD
To prevent damage from electrostatic discharge, always wear an
antistatic wrist strap connected to an ESD jack when performing
maintenance on a Secure Router 4134. Ensure that the wrist strap
makes contact with your skin.
Ensure you have the replacement fan tray module for the Secure Router
4134.
Ensure you have a Phillips #2 screwdriver.
Action
Using a Phillips screwdriver, loosen the screw that secures the fan
tray module.
Grasp the handle on the fan tray module.
Pull the fan tray module from the slot.
Insert the replacement fan tray module immediately.
Secure the fan tray module in the chassis by tightening the retaining
screw.
CAUTION
Do not open the Secure Router 4134 service access panel while
the unit is powered.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 01.02 Standard
10.0 7 August 2007
—End—