34 Nortel Secure Router 4134 hardware components fundamentals
GbE Medium Module
The 10-port 10/100/1000 Ethernet Advanced L2/L3 Medium Module
provides ten autonegotiating 10/100/1000 Mbps copper Ethernet ports and
two SFP Gigabit Ethernet ports (full duplex). Up to ten ports can be in use
at one time. The module is non-blocking. The 10-port GbE Medium Module
provides both Layer 2 switching and Layer 3 routing functionality.
You can use copper port 5 or fiber port 5—you cannot use both
simultaneously (the same holds true for copper port 10 and fiber port 10). If
a copper cable and a fiber cable are connected to the same port (port 5, for
example), the module uses the first active link. If you disconnect the active
link, the module automatically switches to the remaining connection.
The following figure shows the 10-port GbE Medium Module.
Figure 14
10-port GbE Medium Module
Table 18
Cable and connectors
Port
10Base-T (full-
or half-duplex),
100Base-TX
(full duplex),
1000Base-T
(full-duplex)
Fiber ports
Copyright © 2007, Nortel Networks
.
Connector
Recommended
cable type
RJ-45
EIA Category 3,
4, or 5 UTP for 10
Mb/s operation.
EIA Category
5 UTP or STP
required for
100/1000 Mb/s
operation.
SFP module
Typical SFP
Modules:
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 01.02 Standard
10.0 7 August 2007
Minimum
Maximum
cable length
cable length
None
328 ft (100 m)
None