Installing A Medium Module; Installing A Large Module - Nortel Secure Router 4134 Quick Start Manual

42 Installing the Secure Router 4134 chassis and hardware components
4
5

Installing a Medium Module

Use the procedure in this section to install a Medium Module in the Secure
Router 4134. You can install Medium Modules in slots 5, 6, and 7.
ATTENTION
If you use a Voice Carrier Medium Module with the Secure Router 4134, Nortel
recommends you install the Voice Carrier Medium Module in the chassis before
installing Small Modules in the Voice Carrier Medium Module.
Procedure steps
Step
1
2
3
4
5
6

Installing a Large Module

Use the procedure in this section to install a Large Module in the Secure
Router 4134. You can install a Large Module to span slots 6 and 7 only.
Procedure steps
Step
1
Copyright © 2007, 2008 Nortel Networks
.
Push gently, but firmly, to seat the connector on the interface
module in the chassis back panel.
Use a Phillips screwdriver to tighten the two captive screws to
secure the module to the chassis.
Action
Use a Phillips screwdriver to remove the slot cover plate from the
slot in which you will install the module.
Align the module with the slot and the slot module guides.
Slide the module into the chassis until its connector panel
touches the chassis back panel.
Push gently, but firmly, to seat the connector on the interface
module in the chassis back panel.
Ensure the lever on the module is flush with the front panel of
the Secure Router 4134.
Use a Phillips screwdriver to tighten the two captive screws to
secure the module to the chassis.
Action
Use a Phillips screwdriver to remove the slot cover plates from
slots 6 and 7.
Nortel Secure Router 4134
Quick Start
NN47263-100 02.01 Standard
18 February 2008
--End--
--End--