Nortel Versalar 15000 Troubleshooting Manual page 71

When the source of the default image or configuration file is a network, enter only
a dash (
file. If you enter anything else, the BCC displays an error message.
The software image and configuration file revert to their default file name after
every boot. To change the default boot or configuration file, overwrite the old
default file with the new default file, using the
back up the old default file, using the
Examples
boot
boot 9:- 9:-
or
boot 9:v15k.exe 9:config
boot 9:net1.exe 10:-
boot 10:- 9:trident.cfg
boot 9:net1.exe 9:trident.cfg
302768-C Rev 00
) to indicate no volume for the router software image or configuration
-
Managing the Versalar 15000
(copy) command. Be sure to
cp
command, before overwriting it.
cp
The system uses the default router software image
(for example, v15k.exe ) and the configuration file
( config ) on the volume to come up with the valid
boot name.
The system uses the default router software image
on volume 9 and the default configuration file
.
( config ) on volume 9
The system uses the router software image
net1.exe on volume 9 and the default configuration
file ( config ) on volume 10.
The system uses the default router software image
on volume 10 and the configuration file trident.cfg
on volume 9.
The system uses the router software image
net1.exe on volume 9 and the configuration file
trident.cfg on volume 9.
5-5