Using Tftp To Transfer The File - Nortel Versalar 15000 Troubleshooting Manual

Managing and Troubleshooting the Versalar Switch Router 15000
The procedure for using FTP to transfer a copy of a file to a Sun workstation or
PC depends on the implementation of FTP on that system. The following
instructions apply to Sun workstations.
If you are using a PC and need instructions for using FTP, refer to the
documentation for the TCP/IP stack installed on the PC.
To retrieve a packet capture file, enter the following commands at the
command-line interface of the Sun workstation:
Enter the following command to start FTP:
1.
ftp
Enter the following command to establish an FTP connection with the
2.
router:
open <IP_address>
IP_address
Enter the following command to specify that the file to be transferred is
3.
binary:
mode binary
Enter the following command to retrieve a copy of the file:
4.
get <file_name>
file_name
Example
get pcap1000
Enter the following command to terminate FTP:
5.
quit

Using TFTP to Transfer the File

When you use TFTP to get a packet capture file, the TFTP software transfers it
from processor memory instead of from the media.
The procedure for using TFTP to transfer a copy of a file to a Sun workstation or
PC depends on the implementation of TFTP on that system. The following
instructions apply to Sun workstations.
8-22
is the IP address of the router.
is the name displayed after you enter the command.
show pcap
302768-C Rev 00