Figure 1 Front Panel Of The Instant Internet 100-S Unit - Nortel BayStack Instant Internet 100-S User Manual

34 Chapter 3 Instant Internet 100-S hardware installation
• Seven 10/100 Link/Activity LEDs (labeled S1–S7) display port status for the
switch. For details, refer to
functions," on page
• Seven FDX LEDs (labeled S1–S7) display port mode status for the switch.
For details, refer to
page
Figure 1

Figure 1 Front panel of the Instant Internet 100-S unit

The rear panel of the unit contains the following switches and connectors:
• A communications interface (one or two phone jacks, an ISDN jack, or a third
Ethernet connection) for connecting to your telephone service company
(telco) or external Ethernet connection
• Second Ethernet connection (Eth2) to connect to a router or bridge to support
a Demilitarized Zone (DMZ), or to add another network segment
• AUX port to directly connect a PC or modem for out-of-band management
(see
• DIP switches (see
• Power voltage selector switch (115 or 230)
• Power supply connector and power switch
209374-A
57.
Chapter 6, "LEDs: support and diagnostic functions," on
57.
illustrates the front panel of the unit.
1 2 3 4 5 6 7 8 Power
S1 S2 S3
10/100 Link/Activity
FDX
Chapter 7, "Out-of-band management support," on page
Chapter 5, "DIP switch settings," on page
Chapter 6, "LEDs: support and diagnostic
BayStack Instant Internet 100-S
S1 S2 S3 S4 S5 S6
S4 S5 S6 S7
S7
9861EA
61)
51)